Two component Invisible Oil System
Rubio Monocoat Invisible Oil System is two component product, what gives wood a total protection without changing the tone. Invisible Oil System contains two components Invisible Oil ja Invisible Maintenance Oil.
Instruction: Sand the surface. Remove buffing dust with soft brush vacuum cleaner and then clean with Rubio Monocoat cleaner. When the surface is dry, use Invisible oil. Process maximum 5-10m² area at once. Let oil respond some minutes and then remove redundant oil.
Let oiled surface dry at least 12 hours and ensure good ventilation in the room. Then use Inivisible Maintenance Oil.
- Products RMC Invisible Oil and Invisible Maintenance Oil do not mix together!
- Product RMC Invisible Oil does not fit RMC Oil+2C B-component(accelerator)!
- Use product only sanded surfaces!
Rubio Monocoat Limespot Remover is a ready-to-use product that removes lime spots from a surface treated with Rubio Monocoat Oil.
For the cleaning of wooden patios, fences, exterior doors, carports, etc… Removes grey discolouration, mildew stains and dirt. Can be applied on all types of wood.New, weathered as well as treated wood must always be cleaned with Rubio Monocoat Exterior Wood Cleaner before applying one of our Exterior oils.
New wood: Grease that by nature appears in certain types of wood is removed. The natural pigment is cleansed and – as a result – the colour applied afterwards remains stable later on. The pores are opened, which provides more even results.
Weathered and treated wood:
The treatment will degrease and restore the wood. This results in a far more equal colour, which enables better management of the end result.
Do not use this product without consulting the full instruction and technical sheet.
The Rubio Monocoat FR Oil System is an effective combination of two fire-retardant products:
– RMC FR Base: fire-retardant primer
– RMC FR Oil: fire-retardant finishing oil
The unique characteristics of the RMC FR Oil System:
– No build-up of layers, no saturation.
– No solvents or water, 0% VOC.
– Available in all standard interior RMC-colours.
– Manual and industrial application.
– Recommended partner for the project market!
– Optimal performance: low consumption.
This cleaner is used after sanding and vacuum cleaning the untreated wood and before the application is started. With this cleaner you will be able to remove even the smallest dust particles; the perfect start of an impeccable finish.
This product can also be used to clean the used materials after the oil application.
Oil +2C component A is one part of 2- component oil. Use with accelerator
How to use: After sanding, clean the floor from the dust with vacuum cleaner and wash with Rubio Monocoat Cleaner or with clean water. Let the floor dry. Mix oil (A) and acclelerator (B), 3 part oil and 1 part accelerator (example 100g oil and 30g accelerator). Average cost 30-50 m2/l.